Operation Manual

30 31
English
English
N
S
MAGNETISM
CARE OF CASE AND BRACELET
Your watch will not be
affected by magnetism.
To prevent possible
rusting of the case
and bracelet caused
by dust, moisture and
perspiration, wipe them
periodically with a soft
dry cloth.
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet.
• If the watch is left in warm water, a slight time loss or gain may be caused. This
condition, however, will be corrected when the watch returns to normal tem-
perature.
NOTE:
Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the pressure
at a given depth. Care should also be taken on diving into water.
Light activities will not
affect your watch, but be
careful not to drop your
watch or hit it against
hard surfaces, as this
may cause damage.
Be careful not to expose
the watch to solvents,
mercury, cosmetic spray,
detergents, adhesives or
paints. Otherwise, the
case, bracelet, etc. may become dis-
colored, deteriorated or damaged.
SHOCKS & VIBRATION
CHEMICALS
Operational temperature
range: Between -5° C
(+23° F) and 50° C (122°
F)
TEMPERATURES
+50°C
5°C
+40°C
0°C
Display temperature
range: Between 0° C (+32°
F) and 40° C (+104° F)
Functional temperature
range of alarm and LED
light: Between 5° C (+41°
F) and 50° C (+122° F)