CAL.
DISPLAY AND CROWN/BUTTONS Power reserve hand Minute hand Click button Hour hand E V R RES E 0 9 10 2 0 10 3 4 English ER 2 40 PO 30 AUTOMATIC 7 a: Normal position W 8 8 Second hand 2 A 12 1 11 21 Jewels 6 5 b: First click a b CROWN Date
HOW TO START THE WATCH ● This is an automatic-winding mechanical watch. To initially start your watch: Swing it from side to side in a horizontal arc for about 30 seconds, to start the second hand moving. English * If the watch is worn on the wrist, the mainspring will be wound automatically through normal wrist movement.
SCREW DOWN CROWN [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. English 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight.
TIME / CALENDAR SETTING Setting the time and adjusting the date Hour hand Minute hand 1 ➠ E V R RES E 0 9 10 ER 2 40 PO W 30 2 0 10 2 ➠ 1 Press the click button and set it to the date of a previous day. 3 CROWN 3 AUTOMATIC 7 21 Jewels 6 5 ➠ 8 4 8 4 Date Second hand 2 Pull out the crown. (The second hand does not stop.) English 12 1 11 A 3 Turn the crown clockwise until you reach the today’s date. * Advance the hand further and set it to the current time.
POWER RESERVE INDICATOR E V R RES E 2 ER 0 W 30 2 0 10 3 8 4 8 AUTOMATIC 7 6 PO 9 10 12 1 11 40 English Power reserve hand 21 Jewels 6 5 The power reserve indicator shows the amount the watch is wound as an amount of time, so you can see how long the watch will run at a glance. The power reserve hand indicates the remaining amount. The time pointed to by the power reserve hand is the remaining amount of time.
NOTES ON OPERATING THE WATCH TIME/CALENDAR SETTING English ● Do not set the date between 9:00 p.m. and 2:00 a.m. Otherwise, it may not change properly. * If it is necessary to set the date during that time period, first change the time to any time outside it, set the date and then reset the correct time. ● When setting Hour hand, check that AM/PM is correctly set. * The watch is so designed that the date changes once in 24 hours.
English POWER RESERVE INDICATOR 8 ● The remaining time shown is only an approximation. The time shown may be different from actual remaining time. This product has an automatic-winding system which comes with a power reserve indicator function. The mainspring will be automatically wound by your natural arm movements while you wear it on your wrist. The power reserve hand is pointing to the fully-wound position (40H).
SPECIFICATIONS ● Vibration ● Loss/Gain ● Jewels : 21,600 Oscillations / 1hr : Within +25 and –15 second (Daily Rate)* : 21 Jewels English * The mechanism of mechanical watches is very precise and delicate. Time accuracy may change depending of which direction the watch faces.
TO PRESERVE THE QUALITY OF YOUR WATCH WATER RESISTANCE ● Water resistance (5 bar)* English If “WATER RESISTANT 5 BAR” ● Non-water resistant is inscribed on the case back, your If “WATER RESISTANT” is not watch is designed and manuinscribed on the case back, your 5 bar WR factured to withstand up to 5 bar watch is not water resistant, and care should be taken not to get it and is suitable for swimming, yachting and taking wet as water may damage the movement. If a shower.
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the crown is pushed in completely. Do not operate the crown when the watch is wet or in water. If used in sea water, rinse the watch in fresh water and dry it completely. * When taking a shower with the water resistance 5 bar watch, or taking a bath with the water resistance 10, 15 or 20 bar watch, be sure to observe the following: • Do not operate the crown when the watch is wet with soapy water or shampoo.
CARE OF CASE AND BRACELET PERIODIC CHECK English To prevent possible rusting It is recommended that the of the case and bracelet watch be checked once every caused by dust, moisture and 2-3 2 to 3 years. Have your Years perspiration, wipe them watch checked by an periodically with a soft dry AUTHORIZED PULSAR cloth. DEALER or SERVICE CENTER to ensure that the case, crown, buttons, gasket and SHOCKS crystal seal remain intact.
