PARADISE Paradise Showerspa Model #1025-B & 1025-W Owner’s Manual
Paradise ShowerSpa Model 1025–B & 1025–W Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Product Dimensions finished wall line 36¼" 48" 35½" 53" 30¼" 8" 21" 15½" 6" 9¾" 16¾" 9" 9" measured to bottom of mount brackets 11" 6" 3
Parts Legend 2 3 1 19 18 4 16 6 15 5 10 17 14 13 12 9 7 1. ShowerSpa 10 11 2. Escutcheon 3. Shower Arm 4. Rubber Screen Washer 5. Shower Head 6. Stainless Nut 7. Hose Washer.......................2 8. Hand Shower Hose 9. Hand Shower 10. Set Screw.............................3 8 11. Hand Shower Holder 12. Allen Bolt 13. Lock Washer 14. Allen Wrench (2mm) 15. Coarse Thread Screw..........4 16. ShowerSpa Wall Bracket....2 17. Nylon Wall Anchor..............4 18.
Assembly After unpacking your ShowerSpa, some assembly is required prior to installation. Shower Arm Assembly 1. On the back of the ShowerSpa near the top, unscrew the hose fitting from the safety insert (19) and retain rubber washer. Remove the safety insert and discard with plastic nut (18). 2. Place escutcheon (2) over threaded end of shower arm (3) and insert through opening. Use stainless nut (6) to secure shower arm to ShowerSpa. Then secure both set screws (10) located on the stainless nut. 3.
Installation – New Construction Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 2.
Usage Pressure Balance Mixing Valve The Waimea ShowerSpa is equipped with a cUPC® pressure balance mixing valve to adjust water flow and temperature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet), keeping your temperature constant and preventing accidental scalding. To turn on the ShowerSpa simply raise the handle until the desired flow rate is achieved. Rotate to the right to decrease temperature and rotate to the left to increase temperature.
Manufacturer’s Limited Warranty PULSE Shower Spas, Inc. warrants that all ShowerSpas are free from defect in workmanship and/or materials for a period of three years from the date of purchase. This warranty extends to the original purchaser only and is non-transferable.