O A H U Oahu Showerspa Model #1035 Owner's Manual
Oahu ShowerSpa Model #1034 Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Dimensions Back Of ShowerSpa Mount Brackets 74.75" 190 cm 32" 81 cm Approx. 22" 56 cm Approx. Possible Stub-out Locations 39.25" 100 cm Approx. 51.25" 130 cm Approx. Measure From Indents On Bottom Edges Of Brackets To Verify Dimensions 12" 30 cm Approx. 28.
Parts Legend 1. ShowerSpa 8. Hose Clamp......................2 2. Shower Head 9. Allen Wrench 3. Hand Shower 10. Nut...................................4 4. Shower Hose 11. Lock Washer.....................4 5. Hand Shower Holder 12. Washer.............................8 6. Large Nut 13. Bolt...................................4 7. Hand Holder Outlet 14. Mount Bracket.................2 4 15. Mounting Screw (2 extra)..........................
Assembly After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation Handheld Holder Assembly 1. Place the threaded end (opposite the opening for hand shower) of the hand shower holder (5) into the hand shower outlet (7). Make certain the threads for the hand shower hose are pointing down. 2. Tighten hand shower holder (5) to ShowerSpa (1) with nut (6). 3. Tighten hose to the hand shower holder (5) making sure there are no kinks in the hose. DO NOT OVERTIGHTEN. 4.
Installation New Construction or Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 4c.
Usage Thermostatic Mixing Valve The Oahu ShowerSpa comes equipped with a thermostatic mixing valve to safely control water temperature. Once you set the knob to the desired operating temperature, the thermostatic mixing valve will regulate the temperature, keeping it constant even when water pressure drops inside the plumbing lines (i.e. someone flushes a toilet, etc.). The button on the knob points to the current water temperature.
Manufacturer’s Limited Warranty PULSE Shower Spas, Inc. warrants that all ShowerSpas are free from defect in workmanship and/or materials for a period of three years from the date of purchase. This warranty extends to the original purchaser only and is non-transferable.