Monterey ShowerSpa Model #1042-SSB PW-91042-2025BSS Owner's Manual
Monterey ShowerSpa Model #1042-SSB / PW-91042-2025BSS Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Dimensions FRONT 27 in. - 685.8 mm 20 in. - 508 mm 44 in. - 1117.6 mm 59 in. - 1498.6 mm 9 in. 228.6 mm BACK 16.5 in. 419.1 mm 13 in. 330.2 mm 8 in. 203.2 mm 3 in. 76.
Parts Legend 4 1. ShowerSpa 6. Rubber Washer......................5 11. Wall Anchor........................4 2. Shower Arm 7. 90° Elbow/Supply Line.........2 12. Handshower Holder 3. Escutcheon 8. Showerhead 13. Handshower Hose 4. Silicone Gasket............2 9. Screw.......................................4 14. Handshower 5. Nut.................................2 10. Mounting Bracket.................
Assembly After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation Shower Arm Assembly 1. Place escutcheon (3) over threaded end of shower arm (2) and insert through shower arm hole. At back of panel, place silicone gasket (4) over shower arm and secure with nut (5) to ShowerSpa. 2. Attach 90° elbow/supply line (7) to shower arm (2) ensuring rubber washer (6) is still in hose fitting. Do not over-tighten. Handshower Holder Assembly 1.
nstallation New Construction or Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 2.
Usage Pressure Balance Mixing Valve This ShowerSpa is equipped with a cUPC® pressure balance mixing valve to adjust water flow and temperature. The valve automatically adjusts to changes in water pressure (i.e. someone flushes a toilet), keeping your temperature constant and preventing accidental scalding. To turn on the ShowerSpa simply raise the handle until the desired flow rate is achieved. Rotate to the right to decrease temperature and rotate to the left to increase temperature.
Manufacturer’s Lifetime Limited Warranty 1. Defects Covered; Warranty Period. Pulse Shower Spas, Inc. (“Pulse”) warrants to the original consumer purchaser who purchases this shower spa (the “Product”) for use in his or her own home, that the Product will be free from defects in material and manufacturing workmanship for as long as the original consumer purchaser owns that same home.