Eclipse ShowerSpa Model #1060MB-BA-1.8GPM, 1060MB-BA, 1060MB-SSB-1.
Eclipse ShowerSpa Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation. If you encounter any problems during installation PLEASE VISIT CUSTOMER SUPPORT AT WWW.
Parts Legend 1. 2. 3. 4. 5. 6. 7. Escutcheon Shower Arm Washer.......................(9) Showerhead Fitting.........................(2) Body Jets...................(4) Diverter Handle 8. 9. 10. 11. 12. 13. 14. Valve Handle Valve Trim Diverter Body Pressure Balance Valve Diverter Cartridge Flex Hose..................(2) ShowerSpa 15. 16. 17. 18. 19. 20. 21. Wand Hose Jet Body.....................(4) Wand Holder Shower Brackets......(2) Screws........................(4) Wall Anchors.............
Installation Instructions BEFORE YOU BEGIN Measure the following to ensure your ShowerSpa will fit properly. Professional installation may be required. Shut off main water supply New Construction Behind wall stud Preparation for installation: 1. This product can only be installed after having plumbing water supply cold and hot water to the wall. They should be placed where you want to install the shower panel. 2. Check that all the parts are available. 3.
Installation Instructions Retrofit 1 Step 1 Step 3 Step 2 Step 2 Step 4 Step 1 CAUTION: Live Plumbing Step 3 Step 2 [Step 1] After determining the ideal height for the wall brackets, mark the drill marks according to the distance of the holes in the shower brackets. [Step 2] Using a drill, drill the marked holes, being careful not to damage the supply piping. [Step 3] Insert wall anchors into the holes. Be sure to clean off any residue before placing them.
Step 1 Installation Instructions Step 1 2 Shower arm and showerhead assembly 4 Step 2 Step 2 Step 3 Step 1 Step 2 Step 1 Step 2 Step 4 Step 3 Step 2 [Step 1] Place escutcheon (1) betweenStepthe shower 3 arm (2) and ShowerSpa (14). [Step 2] Inside the ShowerSpa (14), place a washer (3) and screw in the fitting (5). [Step 3] Connect the hose (16) to the shower arm (2). DO NOT OVERTIGHTEN. [Step 4] Screw showerhead (4) onto shower arm (2).
Installation Instructions 6 7 Hang the ShowerSpa (14) on the shower brackets (19). The ShowerSpa (14) should sit easily on the top and bottom bracket. Product Fully Assembled Before use, make sure the ShowerSpa (14) is properly connected. Restore the water supply and check the tightness of the assembly. Always remember to turn the valve handle to "off" after every use.
Usage Diverter valve controls the showerhead, handshower, and boy jets functions. Turn diverter to change between functions. Always turn cold water on first to help prevent any accidental burning or scalding; especially for children and elderly. This ShowerSpa is equipped with Spray Straight™ technology in the tips of the showerhead and hand shower. If the stream becomes obstructed from mineral deposits, simply rub the soft tips with your finger to loosen the deposits.
