Installation Guide

5
Assembly
After installing your ShowerSpa, some assembly is required prior to use.
Attaching The Accessories
1. Locate the desired mounting location of the handheld holder (6) and mark the holes (we recommend placing it near the height
of the glass shelf). Drill ¼" holes through wall surface using a masonry bit. Drill slowly through wall surface to avoid cracking and
chipping. Insert anchors and securely screw mount to wall.
NOTE—To adjust angle of handheld shower, loosen knob, gently rotate toward you or toward the wall, then tighten knob.
2. Insert rubber washer (11) into hexagon shaped end of handheld hose (7) and attach to threaded outlet on bottom of ShowerSpa.
DO NOT OVER-TIGHTEN.
3. Insert rubber washer (11) into tapered end of handheld hose (7) and attach to handheld shower (5). Place into handheld holder.
4. Place the female threaded end of the shower arm (3) over the male threads on top of the shower arm bracket (4). Hand tighten
until secure. The shower arm should swing freely from side to side for ideal positioning.
5. Check that rubber washer (11) is in shower head (2) and screw shower head onto the shower arm (3).
Installation – New Construction
Extensive Remodel – New Finished Wall Surface
1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90°
brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished
wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall.
1
2. The height of the stub-outs is completely dependent upon the desired mounting height of your Lahaina ShowerSpa. For a person
5'8" – 6'2" we recommend the stub-outs be 39" from finished floor.
2
3. Before you install the ShowerSpa, make certain water is completely turned off to both hot & cold supply lines of the shower.
4. Mark the location of holes for the mounting brackets, making sure brackets are level. For a person 5'8" – 6'2" tall, we recommend
putting the top bracket 65
5
/ 8" from finished floor height.
3
The bottom bracket should be positioned exactly 23 ¼" below the top
bracket with the holes plumb to the upper bracket holes. Before drilling holes for bracket, make certain ShowerSpa will rest flat
against finished wall surface at desired mounting height with supply lines connected.
5. Drill ¼" holes through wall surface using a masonry bit. Drill slowly through wall surface to avoid cracking and chipping. Insert
anchors and securely screw brackets to wall. Before connecting hot and cold supply lines, hang the ShowerSpa on wall, check the
height and make sure the ShowerSpa is flush against wall with a secure fit.
6. Connect hot and cold water supply lines to stub-outs—DO NOT OVERTIGHTEN. Before mounting the ShowerSpa, check fittings to
make sure they are secure. Turn on water and check for leaks. When fittings are leak-free, mount ShowerSpa on wall.
7. OPTIONAL—Seal around body of ShowerSpa with a bead of silicone. DO NOT SEAL BOTTOM.
1
Additional fittings may be necessary depending on your specific situation.
2
The desired mounting height of ShowerSpa determines height of the ½" stub-outs. The stub-outs must be located at a height al-
lowing supply lines to be connected and body of ShowerSpa to rest flat against finished wall.
3
The mounting height may vary depending on several factors (i.e. location of supply lines, interference from ShowerSpa plumbing,
personal preference, etc.)