Tropicana ShowerSpa Model #1039W-BN PW-91039-5625SFBSS & PW-91039-5618SFBSS Owner's Manual
Tropicana Model #1039W-BN/ PW-91039-5625SFBSS/PW-91039-5618SFBSS Please Read The Following Instructions COMPLETELY Before Beginning! Our goal is to ensure your installation goes smoothly and safely. Please read these instructions carefully and follow recommendations for plumbing and mounting. After reading instructions, if you determine you do not have the necessary skills and/or tools, we recommend that a licensed plumbing contractor complete the installation.
Product Dimensions 5.5 in. 139.7 mm 2 in. 50.8 mm 9.5 in. 241.3 mm Finished Wall Line 34.5 in. - 876.3 mm 48 in. - 1219.2 mm 34 in. - 863.6 mm Measured To Bottom Of Bracket 11 in. - 279.4 mm 9.75 in. 247.65 mm 8 in. 203.2 mm 19 in. - 482.6 mm 9 in. 228.6 mm 53 in. - 1346.2 mm 9 in. 228.6 mm 30.25 in. - 768.35 mm 23.5 in. - 596.9 mm Measured To Bottom Of Bracket 6 in. 152.
Parts Legend Flow Restrictor Placement: 2.5/1.8 gpm restrictor with check valve built-in in the handshower *Performance may be compromised due to flow restrictions 1. ShowerSpa 2. Shower Arm 3. Shower Arm Base 4. Showerhead 5. Rubber Waher......................8 (4 extra) 6. Handshower Hose 7. Handshower 8. Handshower Holder 9. Handshower Holder Nut 10. Mounting Screw...................4 11. Wall Mount Bracket.............2 12. Nylon Wall Anchor................
Assembly After unpacking your ShowerSpa, some assembly is required prior to installation. Shower Arm Assembly Attach shower arm to the shower arm base and secure. Handshower Holder Assembly NOTE— The handshower holder is directional and must be installed so the set screw is facing down in order for the tapered end of the hose to fit properly. 1. Use 4mm allen wrench to remove allen bolt from handshower holder and retain lock washer. Insert bolt through lock washer, then opening on side of ShowerSpa.
Installation – New Construction Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 2.
Installation – New Construction Extensive Remodel – New Finished Wall Surface 1. Prior to sheetrock, stub-out ½" hot and cold supply lines beyond finished wall surface, 4" on center. For best results, attach 90° brass fittings (available at most hardware stores) to the stub-outs maintaining ¼" – ½" of space between the fitting and finished wall. The open end of the 90° brass fittings should point down so the supply lines attach parallel to the wall. 1 2.
MANUFACTURER'S LIFETIME LIMITED WARRANTY 1. Defects Covered; Warranty Period: Pulse Shower Spas, Inc. (“Pulse”) warrants to the original consumer purchaser who purchases this shower spa (the “Product”) for use in his or her own home, that the Product will be free from defects in material and manufacturing workmanship for as long as the original consumer purchaser owns that same home.