Specifications

EMC-CS-2009.1
© Copyright Ford Motor Company – All Rights Reserved Page 76 of 121
February 11, 2010
Figure 19-7: CI 260 Waveform F (Expanded)
-5
0
5
10
15
20
24 25 25 26 26 27 27 28 28
msec
Volts
19.2 Test Verification and Test Setup
Testing shall be performed using the test Setups shown in Figure 19-8 through 19-10. The test harness connecting the DUT
to the Load Simulator and transient pulse generator shall be <
2000 mm in length.
Figure 19-8: CI 260 Test Setup Detail for Waveforms A , B and C
RR
DD
Signal Source Detail
DC Coupled
Audio
Amplif ier
Arbitrary
Wavef orm
Generator
Test FixtureTest Fixture
DUTDUTDUTDUT
Waveform
Generator
Signal
Source
OscilloscopeOscilloscope
*
D : Fast Recovery Diode (e.g. MUR 3080)
R = 2 Ohms *
* The resistor value may be increased when testing components powered from a regulated supply (category
AS). The value of this resistor shall be mutually agreed to by the FMC EMC department and the
component’s D&R activity. The resistance value shall be documented in the component’s EMC test plan.