Operating Instructions PRO-12
If you sell, inventory or service lead-acid batteries, you want the battery you take off the shelf to be as new as the day it was manufactured. However, batteries that sit idle continually discharge and are subject to a naturally occurring build-up of lead sulfate deposits that reduce the battery’s ability to accept, store and release energy. The RediPulse Pro-12® tackles both problems.
b) To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer and manufacturer of any equipment you intend to use in vicinity of battery. Review cautionary marking on these products and on engine. 11. PERSONAL PRECAUTIONS a) Someone should be within range of your voice or close enough to come to your aid when you work near a lead-acid battery. b) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
c) Charger is designed to be installed on a battery rack header card (Fig.1), but it may also be installed on the side of the battery storage rack, on a shelf within reach, or permanently mounted to the wall using the enclosed mounting hardware. d) Never allow battery acid to drip on charger when reading gravity or filling battery. e) Do not operate charger in a closed-in area or restrict ventilation in any way. f) Do not set a battery on top of charger. 14.
Operating Instructions PREPARATION FOR SERVICE & OPERATION • Inspect the Pro-12 charger for visible damage which might have occurred during shipping and delivery. • Plug the AC adapter into an electrical outlet (110-volt or 220-volt depending on unit). NOTE: This adapter is specially designed for this unit. DO NOT use any other adapter. If the adapter has to be replaced at some point in time, contact PulseTech to order another one.
TWO-YEAR LIMITED WARRANTY What Does This Warranty Cover? This warranty covers any defects in workmanship or materials in any circuit board in the Pro-Series™products under normal use and service. How Long Does The Coverage Last? This warranty runs for two (2) years from the date of purchase. What Will PulseTech Do? PulseTech will, at its option, replace or repair any defective circuit board with a new or rebuilt circuit board at no charge.