Product Manual

10
9-4
Store the air compressor in a clean and dry location
10
TROUBLE SHOOTING
CONDITION CAUSE CORRECTIVE
Compressor do not start
1Fuse blown or circuit
breaker tripped
2Loose electrical connection
3Motor overheated
1
Check for cause of blown fuse or
breaker and replace or reset
2Check wiring connection
3Press reset button or wait for
automatic reset Check belt
tension
Low pressure
1Air leak in safety valve
2Loose tube of fittings
3Restricted air filter
4V-belts loose
5Defective check valve
1Safety valve manually by pilling
upward on ringIf condition
persists replace valve
2Tighten fittings
3Clean or replace
4Adjust belts tension
5Replace check valve
Safety valve releasing on air
receiver tank
1Defect pressure switch or improper
adjustment
2Defective safety valve
1
Check for proper adjustment and
if problem persists replace
pressure switch
2Replace safety valve
Oil discharge and excessive
carbon formation or
appearance of water and oil in
the air lines
1Improper oil viscosity
2Overfilling the crankcase
with oil
3Restricted air intake filter
4Carbon exhaust valves
5Worn valves
6Worn piston rings
7High ambient temperature
and/or humidity
8High percentage of running
time
1Replace oil with SAE10W-30
non-detergent compressor oil
2Drain oil and fill to proper level
3Clean or replace filter
4Clean or replace
5Replace valve assembly
6Replace piston ring
7Install a moisture separator
and/or dryer follow by and oil
filter
8Check for air leakage
If no leaks
are found you may required an
additional compressor unit as
your air demand is too much
for existing unit
`V-belt roll off the flywheel or
motor pulley
1
Flywheel and motor pulley not aligned
properly
2Belts do not match flywheel groove
3A nick or tear on the edge of the belt
4
Not a matched set(if two or more belts
are used)
1Align using a straight edge
2Purchase new set of matched
belts
3Purchase new set of matched
belts
4Purchase new set of matched
belts