Polymaster™ Bulletin PM-13 W h e r e I n n o v a t i o n F l o w s www.neptune1.
Polymaster™ Neptune Polymaster™ dilutes, mixes and thoroughly activates emulsion, dispersion and solution polymers, including new high-molecular-weight products. Polymaster provides state-of-the-art polymer activation and blending through the use of the patented, motorized Gatlin distribution head.
Gatlin Distribution Head The patented, motorized Gatlin distribution head hydraulically segments polymer into ultra-thin film platelets, maximizing the polymer surface area exposed to dilution water, providing maximum activation. Degree of activation is not affected by fluctuating water pressures or dilution-water ratio changes. How It Works The Gatlin provides a rapid, high-energy initial introduction of polymer to water followed by gentle, low-shear mixing in a multi-stage static mixer.
Polymaster™ Standard Models Selection Chart All Models Except Post Dilution Standard Automatic Units Standard Manual Units The following models may be specified with any electronic metering pump from the chart below. Note: only electronic metering pumps may be used with standard units. Motor-operated diaphragm pumps, gear pumps or progressing cavity pumps must be used with remote units (see chart on opposite page).
Polymaster™ Remote Models Selection Chart Remote Pump Automatic Units Remote Pump Manual Units The following models may be specified with any automatic electronic metering pump (see chart on opposite page) or with any motor-operated metering pump from the automatic pump selection chart below. These models may also be used with progressing cavity type pumps.
Flow Diagrams Legend 1 2 3 4 5 All Models Except PAD-3000R & PMD-3000R Polymer Metering Pump Injection/Check Valve Gatlin Distribution Head Water Pressure Gauge Solenoid Valve 6 Dilution Water Adjusting Valve 7 Flowmeter 8 Water Differential Pressure Switch 9 Static Mixer and Viewing Cylinder Models PAD-3000R & PMD-3000R Specifications Minimum water pressure required: 1.7 bar (25 psi) Maximum operating pressure: 6.9 bar (100 psi) Pressure drop across unit less than: 1.
Polymaster™ Accessories Desiccant breather mounts to 19 mm (3/4") or 51 mm (2") bung on 208-liter (55-gallon) drum, preventing moisture-laden air from contaminating polymer. Particularly useful in low-feed-rate applications. Model PB1 Drum suction wand assembly mounts to 19 mm (3/4") bung for convenient feeding from drums. Model PSW75 DRUM MIXER DESSICANT DRYER 19 mm (.75") NPT DRUM WAND 19 mm (.75") NPT BUNG HOLE 51 mm (2.
PSG Brands ABAQUE™ PERISTALTIC PUMPS mouvex.com MAAG PUMP SYSTEMS EXTRUSION PUMPS & SYSTEMS maag.com ALMATEC® AIR-OPERATED DOUBLE-DIAPHRAGM PUMPS almatec.de AUTOMATIK PELLETIZING SYSTEMS maag.com BLACKMER® VANE PUMPS & COMPRESSORS blackmer.com FLUID DYNAMICS™ POLYMER BLENDING SYSTEMS fluiddynamics1.com GRISWOLD™ CENTRIFUGAL PUMPS griswoldpump.com MAAG FILTRATION PLASTIC MANUFACTURING & PROCESSING FILTRATION maag.
