Instructions / Assembly

TEST THE SYSTEM IN THIS ORDER!

USE WATER! CHECK FOR LEAKS!

The PumpSpy controller has an external cellular antenna.

Mount the antenna as high as possible, preferably attached

to a floor joist or external wall. Remove the backing from the

antenna's mounting tape, and fasten the antenna.

Lift the lowest battery backup switch and hold. Release

when the battery backup pump cycles. The PumpSpy

controller should sound an alarm with the message

Backup On AC On. The SYSTEM light will turn red.

ONLY if the system displays a HI PRIMARY AMP

warning when the main pump cycles, you need to

clear the PumpSpy controller's internal memory.

Insert a pencil or pen to press the recessed reset

button located on the left side of the PumpSpy

controller. The STATUS lights will cycle and the

system will reset to factory defaults. Repeat steps

12 and 13.

The DATA light will turn blinking green after the

homeowner registers the unit at www.pumpspy.com.

Lift switch for the primary sump sump. Release when

pump cycles for at least 3 seconds. The PumpSpy

alarm will stop and the SYSTEM light will be green.

Plug PumpSpy controller into a household AC outlet.

The PumpSpy system will initialize and boot up. After booting,

the POWER and SYSTEM lights should be GREEN. DATA

light should be BLINKING RED.

Connect the PumpSpy controller to the battery.

Red to +, Black to -. Replace and lock lid on case.

Open the battery case and place battery inside.