Installation Guide

10
INSTALLATION - PART 2
4. CONNECT OTHER DEVICES TO THE LOWER
STANDARD OUTLET, IF APPLICABLE.
5. INSTALL THE HIGH WATER SENSOR, CLAMPING TO
THE DISCHARGE PIPE
OF YOUR SUMP PUMP.
A. Adjust the position of the mounting bracket so the high
water sensor does not interfere with the operation of the
main sump pump switch.
B. Adjust the height of the mounting bracket so the high
water sensor is activated when the water level reaches
approx. 1” higher than the “on” level of your main sump
pump.
C. If you have a secondary sump pump/battery backup pump,
make sure the high water sensor is activated BETWEEN the
“on” level of the main sump pump and the “on” level of the
secondary/backup pump.
PUMPSPY HIGHLY RECOMMENDS THAT YOU ALWAYS
HAVE 2 WORKING SUMP PUMPS INSTALLED IN
YOUR HOME, ONE OF WHICH CAN OPERATE IN THE
EVENT OF A POWER OUTAGE. THE PUMPSPY SUMP
PUMP SMART OUTLET WILL NOT OPERATE YOUR
SUMP PUMP IN THE EVENT OF A POWER OUTAGE.
ALTHOUGH PUMPSPY WILL SEND YOU ALERTS WHEN
YOUR PUMP HAS AN ISSUE, WE RECOMMEND HAVING
A BACKUP PUMP THAT CAN TAKE OVER PUMPING
DUTY UNTIL REPAIRS CAN BE COMPLETED.
The High Water Sensor
be mounted 1 ” higher
than the “on” level of
main sump pump