Installation Guide
11
This device complies with part 15 of the FCC and Industry
Canada license-exempt RSS standard
(
s
)
. Operation is
subject to the following two conditions:
(
1
)
this device may
not cause harmful interference, and
(
2
)
this device must
accept any interference received, including interference
that may cause undesired operation. FCC NOTE: The
manufacturer is not responsible for any radio or TV
interference caused by unauthorized modications
to this equipment. Such modications could void the
user’s authority to operate the equipment. NOTE: This
equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
Important note: To comply with the FCC RF exposure
compliance requirements, no change to the antenna or
the device is permitted. Any change to the antenna or
the device could result in the device exceeding the RF
exposure requirements and void user’s warranty.
Thank you for purchasing a
PumpSpy Sump Pump Smart Outlet!