Specifications

Key Panel
Electrical Connections for 12VDC motor functions are made at the molded plugs at the
engine. One 20' extension cable is supplied with each system. There is a 25-amp fuse at
the engine for panel and wire protection. The engine is supplied with oil pressure and
temperature switces, and will shut down the engine in the advent of a malfunction. A red
LED on key panel would indicate this.
Key Panel includes:
1. Key Switch
2. Hour Meter
3. Toggle-Adjustable Speed Control for manual control of engine throttle
4. Toggle switch to turn ON-OFF system alternator
5. Digital voltage meter indicating system voltage - gray wire at ESC box should be
connected directly to positive post at battery bank Wire should be fused near battery
at three (3) amps..
6. Mini toggle switch for ON-OFF system voltage meter
7. Pre-Heat, Run, and Alarm LEDs.
PARTS REQUIRED FOR INSTALLATION
Following is a general list of parts needed for installation. This is just a general list, as all
boats are different and installation is unique to each one.
Mounting Genset
1. (8)
5
\16 Hex Bolts or Lag Bolts, w/nuts and washers as needed. Primary Fuel Filter
and Water Separator w/ fittings
2.
1
/4
" Fuel Hose w/clamps (fuel supply)
3.
1
/4" Fuel Hose w/clamps (fuel return)
Fittings as needed to install hoses to boats fuel system
Seawater Supply
1. Seawater Through-Hull fitting (
3
/4" or larger)
2. Seawater Intake Valve (ABYC approved)
3. Sea Strainer (minimum ¾")
4. Vented Loop fitting, optional (not necessary if mounting above water line).
5. Fittings as needed to make up intake valve, sea strainer and through-hull
6.
5
\8" or
3
\4" Intake Hose w/clamps
Exhaust System
1. Exhaust Through-Hull fitting (1¾")
2. Water Lift Muffler (1¾")
3. 1
3
\4" Marine Exhaust Hose w/clamps
Starting System
1. Start Battery w/lugs
2. Start Battery Cables (minimum #6 AWG) w/terminals
- 7 -