Instructions / Assembly

[e-mail] call: 844-377-5786
11
FLAME
The flame will be cycled from Flame A –
Flame B – Flame C – Flame Off.
Flame A: full bright flame + little blue
Flame B: full bright flame
Flame C: half bright flame
HEATER
The heater will be cycled from Low – High –
Heater Off. The indicator light on left to
Power Switch (see the right picture on last
page) will illuminate when the heater is
turned on. The indicator light will go out
within 10s.
Low: (●○)
High: (●●)
Note:
1. Heater can be used without flame.
2. The heater will work when the
temperature set by thermostat is higher
than room temperature.
3. The Fan works about 10s ahead of the
heater, and stops about 10s later than
the heater.
4. The indicator light in the lower fuel bed
(see the left picture on last page) always
illuminates when heater is on.
5
4
3
2
1
9
6
7
8
THERMOSTAT
Turn it to setting 9 first and when the room
has reached a desired level, turn the rotary
switch counterclockwise slowly until the
thermostat just ‘clicks’ off. The thermostat
will then maintain the room at this selected
level. To increase the temperature, turn the
rotary switch clockwise to a higher setting.