Instructions / Assembly

ASSEMBLY INSTRUCTIONS
Step 1: Assemble the Ladder Risers
A. Lay Ladder Risers on a at surface as shown above.
B. Place 2x Steps on the ground so that the thicker edge of the step is facing away from you, and the
stepping surface slopes down towards you. Flip the steps over as pictured on the above right, and
slide them onto the Ladder Risers.
C. Insert the Foam Cushions onto the ends of the Ladder Risers.
D. Turn the Ladder Risers inwards and insert the smaller end into the larger.
Note: You will have to lift the Steps up towards the hook end of the Ladder Risers to create enough
room for the Riser ends to join together.
NOTE: DO NOT ATTACH THE STEP LOCK HOUSINGS YET.
Note: When placing the Step Lock Housings onto the ladder in
the next step, make sure that the side shown on right is facing
out from the sides of the ladder. There are tabs in the holes on the
Steps which need to slide into the locking mechanism of the
housing. This side will be facing out to the left on the Left Riser,
and to the right on the Right Riser. As such, you will have the
open seam facing up on one Step Lock Housing and the open
seam facing down on the other.