Instructions / Assembly

11
MODEL# 9314TS - ENCLOSURE
ASSEMBLY INSTRUCTIONS
STEP 4:
Place the Enclosure Net (Part 9) on top
of the trampoline. Align the straps to the
corresponding Enclosure Poles so they are
as near to each other as possible when lifted
NOTE:
Make sure that zipper and buckle snap are
facing the outside of the trampoline. This
is good to ensure that Enclosure is not
reversed.
STEP 5:
To keep the net attached to the Jumping Mat,
slip the hooks at the bottom of the Enclosure
Net through the nearest V-Ring slot, and
hook to an adjacent V-Ring as shown.
Continue to do this until all hooks on the
enclosure are attached in this way.
STEP 6:
A. To attach the enclosure netv to the Pole
Caps, grab the corresponding strap at
the top of the Enclosure Net and slip
through the opening of the Pole cap.
B. Detach the snaps by pushing on the
middle of the buckle.
C. Connect Male Buckle Snap (Fork Side) to
the strap.
D. Once Male Buckle snap is fastened,
Re-attach to the other side of the buckle.
E. You will successfully connect both sides
when you hear them click.
B
A
C
D
E