Owner Manual

10
[e-mail]
1-866-498-5269
ASSEMBLY INSTRUCTIONS
STEP 3:
WARNING: To avoid your fingers becoming
caught during assembly, you must attach
the bolts only as noted below.
A. Attach 2x Seesaw Legs (L) to the Upper
Support Tube: Using 2x M6 110mm
Bolts, 4x M6 Washers, 4x M6 Lock
Washers, and 2x Nuts attach 2 Legs (L)
to the Upper Support Tube (I) as shown
in the diagram. NOTE: The (L) Legs must
go into the upper pair of pre-drilled Bolt
Holes in the Support Tube.
B. Attach remaining 2x Seesaw Legs (O) to
the Upper Support Tube:
Using 2x M6 110mm Bolts, 4x M6
Washers, 4x M6 Lock Washers, and
2x Nuts attach 2 Legs (O) to the Upper
Support Tube (I) as shown in the
diagram.
NOTE:
The (O) Legs must go into the lower pair of
pre-drilled Bolt Holes in the Support Tube.
Ensure that the legs have been assembled
correctly and are even at their bases before
continuing
STEP 4:
Line up the Upper Support to the Hole in
the center of the Main Bar.
Secure the Swivel to the Main Bar using the
70mm Hex Bolt (C), 2x M8 Washers (S), 1x
M8 Lock Washer (T), and 1x M8 Nut (U).