Owner Manual

9
MODEL# 9307SS
STEP 2:
A. If not already present, see saw a Small
Plastic Tube (V) onto the end of each Side
Bar (K) you assembled. Next, see saw
the bars into the Main Center Bar (H) as
shown in Figure 3.
B. Formation 1 (Extended, below left):
Secure with 2x M6 60mm Bolts (B) 4x
M6 Washers (F), 2x Lock washers (G) 1x
M6 50mm Bolt (D1), 2x M6 Washers (F),
and 1x Lock Washer (G) using the left
diagram in Figure 4.
Formation 2 (Standard, below right)):
Secure with 2x M6 60mm Bolts (B) 4x M6
Washers (F), 2x Lock washers (G), using the
lower right diagram in Figure 4.
It is recommended that you start off with
the bars at equal lengths, and adjust only if
necessary due to a significant difference in
height or weight of the children using this
seesaw.
NOTE:
If you do not use the D1 bolts, be certain
that you keep these bolts in a safe place in
case they are needed in the future.
ASSEMBLY INSTRUCTIONS