OBC Series Modular Fiber Optic DVI Extension System Owner’s Manual Dtrovision LLC 9A Bergen Turnpike Little Ferry, NJ 07643 USA Tel: +1.201.488.3232 Fax: +1.201.621.6118 Email: support@dtrovision.com www.dtrovision.com For order support, please contact your local dealer. For technical support, please contact us at support@dtrovision.
Welcome! Congratulations on your purchase of model OBC, the fiber optical DVI extension system. This manual contains information that will assist you in installation and operation of the product. Product Description The OBC modules offers 100 meters extension of high-resolution digital graphic data over fiber, directly connected between digital video source and displays. OBC receiver module is to be connected to the video display using short DVI cable(Not included).
System Requirements for Setup Hardware requirements You must have a video source with a DVI (Digital Visual Interface) output port. It should support the maximum graphic resolution feature of the display to be connected. In case of using a computer, no special memory size, CPU speed and chipsets are required. Proper initial trial of the entire platform with its application using a short length copper cable is recommended prior to installation of this system.
Installation Important: Please use the installation procedure below. Improper, or no operation may result if the start-up sequence is not correctly followed. Step 1 Carefully unpack the contents of the shipping group. Step 2 With system power turned off, connect the upstream Transmitter box to the DVI receptacle of a media receiver or a computer by one DVI copper cable in the shipping group.
Warning: Please DO NOT look directly into the LC receptacles of the Transmitter box, while it is powered on, although this product is regulated strictly enough to operate under the Laser Class I, classified by CDRH/FDA for eye safety. Step 4 Remove the module dust covers and connect each duplex LC fiber cable one by one to each of 4 LC receptacles of the Transmitter and Receiver boxes, as shown in Fig. 4. Plug A to A and B to B.
Troubleshooting The display displays only black screen. Check that all AC and DC plugs and jacks used by external power supplies (both PureLink and others) are firmly connected. Ensure that power bars are live. Ensure that the Tx and Rx boxes plug correctly to the media receiver or computer and display, respectively. Check if the media receiver or computer and display are powered on and properly booted. Re-boot up the system after reconnecting the optical system cable.
Product Specifications OBC Fiber Optical DVI Extension Modules Compliance with DVI standard: supports DVI 1.0, using fiber-optic communication links and DDC2B. Extension limit: 100m (330feet) for UXGA (1,600x1,200) at 60Hz refresh (or, 1080p) Graphic Transmission Bandwidth: supports up to 1.65Gbps bandwidth per graphic channel at UXGA at 60Hz. Fiber-optic Connection: The transmitter and receiver boxes of OBC have 2 duplex LC receptacles connected to four 62.
Warranty Information 1 (One) Year Warranty Dtrovision warrants this fiber optical DVI extension cable to be free from defects in workmanship and materials, under normal use and service, for a period of one (1) year from the date of purchase from Dtrovision or its authorized resellers.
FCC/CE Statement This device complies with part 15 of FCC Rules and EN 55022/55024/61000-3 for CE certification. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must not accept any interference received, including interference that may cause undesired operation.