User's Guide

Figure 5.4 – Over Temperature Derating Notification
Figure 6.1 – Charging a One-Battery Pack System on a Boat
Figure 6.2 – Charging a Two-Battery Pack System on a Boat
Figure 6.3 – Charging Two Battery Packs Off of the Boat, Using the Battery Pack Receptacle
Terminating Plug
Figure 7.1 – The Pure Watercraft Mobile App icon, Mobile App available for Free Download
Figure 8.1 – Outboard Supported by a Transom Saver
Figure 9.1 – Tilt Lock in the Locked Position
Figure 10.1 – Appropriate Clearance Between Transom Edge and Inside of Transom Bracket
Figure 10.2 – Outboard Mounting Template
Figure 10.3 – Bolts Aligned in Transom and Outboard
Figure 10.4 – Tightening Bolts with Wrench and Ratchet Extension
Figure 10.5 – Applying Marine Grease on Steering Cable
Figure 10.6 – Inserting the Steering Cable into the Steering Tube
Figure 10.7 – Tighten the Nut on the Steering Tube
Figure 10.8 – Steering Linkage Assembly
Figure 10.9 – Attaching Steering Linkage to Outboard’s Steering Arm
Figure 10.10 – Insert Steering Linkage on Steering Cable Hole
Figure 10.11 – Secure Steering Linkage to Steering Cable
Figure 10.12 – Apply Marine Grease on Propeller Shaft
Figure 10.13 – Bow Side Propeller Thrust Washer on Propeller Shaft
Figure 10.14 – Tightening Propeller Nut
Figure 10.15 – Tightening Tail Cone Fasteners
Figure 10.16 – Underside of Throttle Showing Mounting Hole Pattern
Figure 10.17 – Auxiliary Output Connector Cap Attached
Figure 10.18 - Throttle Mounting Bracket (short)
Figure 10.19 - Throttle Mounting Bracket (tall)
Figure 10.20 - 12V Buffer Battery Wiring Diagram
Figure 10.21 – Battery Pack with Power Data Cables Connected
Figure 10.22 - Charger Mounting Template
Figure 11.1 – New Sacrificial Anode
105