User's Guide

8. Number of batteries connected.

Please note that GPS-based range calculation is an estimate which does not consider either

water current or wind conditions. Changes in speed, direction, wind, and currents may have

an unaccounted impact on the remaining range value displayed.

Secondary Main Screen

The Secondary Main Screen is accessed from

the Main Screen by pressing the Next button.

The Secondary Main Screen shows more

operating details than visible on the Main

Screen.

To return to the previous screen (Main Screen),

press the Next button again.

1. Speed of travel – the default units will be

miles per hour. This can be updated to show

kilometers per hour or nautical miles per

hour via the Settings section of the Mobile

App (see Section 7.7).

2. Power consumption – the amount of power

consumed by the system at the current

throttle position, measured in kilowatts.

3. State of Charge – the percentage of full

charge capacity of the connected Battery

Pack(s). If multiple Battery Packs are

connected, the percentage is an average

cumulative measure.

4. Time and distance remaining – this value is

an estimate of the remaining time and

distance (default setting is miles) that can be

traveled before running out of Battery power,

based on the current power level and speed

at which the boat is operating. As the

operating power increases, the remaining

range will decrease. (See section 5.3).

5. Motor RPM – Speed at which the electric

motor is rotating. There is a gearbox

between the motor and propeller so the

propeller speed is slower than the motor

speed shown in this display.

6. Outboard tilt/trim angle – the current trim

angle of the motor, relative to vertical.

7. Heading – the direction that the bow of the

Figure 4.30 – Secondary Main Screen