User's Guide

4. Put the 1” washers and nuts on the bolts and tighten just enough to keep the Outboard
in place. It is best to tighten all of the nuts once all four bolts are in place.
5. Insert the remaining two bolts and 1.25” washers into the bottom holes on the transom,
starting from the inside of the transom and pushing out.
6. Attach the remaining two 1” washers and nuts to each of the bottom bolts.
7. Tighten using the wrench and ratchet extension.
Figure 10.4 – Tightening Bolts with Wrench and Ratchet Extension
10.4.4 Connecting to the Steering – Starboard Side Cable
Parts:
Description
Quantity
Steering linkage
1
78