User's Guide

Figure 10.13 – Bow Side Propeller Thrust Washer on Propeller Shaft
3. Align propeller with the hub and push on to the shaft until it abuts the bow side thrust
washer.
4. Put the stern thrust washer (with the wider diameter facing away from the propeller),
propeller washer, and nut onto the shaft.
5. Tighten the propeller nut.
Figure 10.14 – Tightening Propeller Nut
6. Add Loctite 222MS Threadlocker to the threads of each fastener.
7. Insert fasteners in the tail cone.
8. Place the nose cone on the Outboard, aligning the fasteners.
9. Use a 4 mm Allen wrench to tighten the fasteners to 5 newton meters (Nm) +/- 0.5 Nm.
85