User's Guide

ISO4762-M6x10-A4-70
M6x10 316 stainless steel screws
4
N/A
Split grommets
2
N/A
Throttle Cable
1
N/A
Auxiliary Power Output Cable*
1
N/A
Auxiliary Output Connector Cap**
1
*Use if connecting 12 volt power to onboard electronics or a 12 volt battery.
**Use if not connecting 12 volt power to onboard electronics or a 12 volt battery.
Figure 10.18 - Throttle Mounting Bracket (short)
Figure 10.19 - Throttle Mounting Bracket (tall)
1. Secure the mounting bracket to the side of the hull using the mount backing plate, the
flat washers, and the M5x40 screws.
a. Place the Throttle mounting bracket in the desired location at desired height on
the side of the hull. Use a pen or marker to mark the placement of the four
perimeter mounting holes and the center two cable routing holes on the side of
the hull.
b. For the perimeter mounting holes, drill four holes of ⅜” diameter through the
hull’s inner sidewall. For the center cable routing holes, drill two holes of 1”
diameter through the hull’s inner sidewall.
89