User's Guide

Figure 10.21 – Battery Pack with Power Data Cables Connected
3. Connect the Power Data Cable running from the Battery Pack(s) into the receptacle on
the Outboard and secure the Power Data Cable using the rubber Cable strap (#2 in
Figure 4.2 in Section 4.2.1).
10.8 Mounting the Charger
The Charger was designed to be either a stationary or a portable device, depending on the
vessel’s charging location. It can be mounted to a wall or pedestal where regular charging will
occur, such as a garage or dock, or it can be stored on its own or in the boat and be carried
using the handles (weighs 24 lbs) to the location of charging.
The Charger can be mounted on the wall using 4 screws.
Description
Quantity
Number 10 size stainless steel screw, 1” long
4
4. Use the Charger Mounting Template below to drill 4 holes of ⅛” diameter (#21 drill bit
size). The holes are 5” apart in the Y axis and 15.25” apart on the X axis.
92