User's Guide

12 TROUBLESHOOTING
System Startup
Issue
Troubleshooting Steps
Throttle does not power on.
1. Confirm that the Throttle Cable is properly connected to
the Battery Pack.
2. Confirm that the Throttle is properly connected to the
Throttle Cable on the underside of the Throttle.
3. Confirm that all other system components are securely
connected.
4. Connect Charger to one Battery Pack receptacle while
the Throttle Cable is connected to the other receptacle
and turn the Charger On. Leave the Charger On for at
least 10 minutes (even if the Battery Pack is fully
charged), then attempt to power on the Throttle.
Restart screen persists
after pressing the “Restart”
button.
1. Shut down and restart the Throttle by holding down the
Power button until the screen goes black.
2. Press the Power button to power on again.
System Operation
Issue
Troubleshooting
System does not run at full
power.
1. Compare the icons displayed to those shown in Section
4.5.7 of this User Guide.
2. Depending on the notification shown, follow the remedy
steps listed in Section 4.5.7.
System overheating
notification persists.
1. Stop operation of the Outboard by putting the Throttle in
the neutral position.
2. Ensure that the Battery Pack(s) are not in direct
sunlight.
3. Ensure the Battery Pack(s) have adequate airflow by
removing any obstructions from all sides of the Battery
Pack(s).
Tilt/trim button does not
raise or lower the motor.
1. Verify that the Throttle is powered On.
2. Confirm the Tilt Lock is not engaged.
3. Wait 45 seconds and then attempt to engage again.
4. Verify that all system Cables between the Throttle and
the Outboard are properly connected.
97