Operation Manual

6
Display
Brightness
Change the screen brightness between Low and High.
Standby mode
Set the Backlight On or Off for when your radio is in standby.
Sw version
Displays the version of the software in your radio. You may be asked to quote this if you contact Technical Support.
Sw upgrade
You can upgrade the software in your EVOKE-1
XT
Marshall Edition using a PC connected to the USB port on the rear
panel. To upgrade, select Sw upgrade and follow the instructions provided with the software. Upgrades may be issued to
provide enhanced functions or improve performance. Register your product online or check our website at www.pure.com
for details of when software upgrades are available. To exit the software upgrade menu press the Menu button again.
Hints and tips
(<</>>) Secondary services
Secondary services ‘<<’ provide extra information or content and may only be broadcast at certain times. If a station has secondary services
available the display will show ‘>>’ next to the station name and the services appear next to the primary station on the station list.
(?) Inactive or unavailable DAB stations
Inactive or unavailable stations are those which appear on the station list but are not currently available. Inactive stations have a ‘?’ before
their name on the station list. If you select a station which has this symbol, your radio tries to tune in or returns to the previous station.
Display says ‘No stations available’
Check that your aerial is fully extended. Use Autotune to search for stations. Try using the tuning aid to adjust your aerial or radio position.
My alarm didn’t work
Make sure that the alarm is set to ‘On’. If a radio alarm, make sure the volume is turned up and you don’t have headphones plugged in.
Resetting your radio
Resetting your EVOKE-1
XT
removes all presets, stored stations and favourite station settings and resets all options to defaults. To reset:
1. Press and hold the Menu button for three seconds. The screen shows ‘Press Tune to confirm reset’.
2. Push the Tune knob to confirm the reset or press no buttons to cancel the reset.