Technical data

Output area
If you intend to define an output block for the corresponding slave on the
DSAP, this block of continuous bytes is specified here.
from: The first byte of the output block.
to: The last byte of the output block.
It is possible to assign the output areas more than once using a different L2
address.
Input area
If an input block is intended, it is defined here. Multiple assignment is,
however, not possible.
from: The first byte of the input block.
to: The last byte of the input block.
M: Here, the number of entries in the internal polling list is
specified. This also specifies the priority of the link
(range of values: default 1, otherwise 1...4).
Output fields
:
L2 station
address:
The L2 station address of the station for which inputs
and outputs are to be assigned to a slave station.
Input/output area
Here, the I/O area in which the variables to be configured will be simulated,
is displayed.
Default SAP: Here, the specified default SAP is displayed (refer to
Section 6.5.3 network parameters). If the CP 5430 TF
is to transmit via the default SAP with ZP, the default
SAP must be set to SAP number 61.
from: The first byte of the block.
to: The last byte of the block.
(range of values in I/O area, configured area).
B8976060/02 Communication with Cyclic I/Os
10 - 25 Volume 1