Technical data

11.6.2 Assigning Parameters to DP Slaves
For each DP slave to be addressed with the DP service, parameters must
be assigned using the screen "Edit->I/Os->DP Slave Parameters". This
information such as "Slave L2 address" and "Slave Vendor Identification", is
required later separately for each DP slave during data exchange. 32 DP
slaves can be assigned.
DP slave parameter assignment can only be called when no CI (CP 5431
FMS) or ZP (CP 5430 TF) has been configured and an I/O area has been
reserved for DP.
Once you have entered more than 25 bytes of user assigned data, the
symbol ">" appears at the end of the field. To enter more than 25 bytes,
you must change to the next screen User-Specific Parameters by selecting
F6 USER PAR.
DP Slave Parameter Assignment
Slave L2 address
Slave name
F
1
F
2
F
3
F
4
F
5
F
6
F
7
F
8
OK
SELECT
HELP
USER PAR
Check slave sync mode
Check slave freeze mode
Slave watchdog time
:
:
:
OFF
ON
OFF
Slave vendor ID
Slave group ID
:
:
0000
User-selectable data :
Length : 0
00000000
CP type:
Source:
(EXIT)
:
:
+1
- 1
NEW
DUPLICATE
DELETE
Fig. 11.14 DP Slave Parameter Assignment Screen
Distributed I/Os (DP) B89060/02
Volume 1 11 - 26