Technical data

Configuring with COM 5430 TF/COM 5431 FMS
To assign parameters to the CP 5430 TF/CP 5431 FMS for the DP service,
several steps are required:
➣
First, the basic configuration of the CP must be specified. This is
described in detail in Chapter 6.
➣
After the basic configuration, the input/output area for the I/Os used
must be specified.
➣
Using "DP slave parameter assignment", you specify the parameters for
each DP slave to be addressed.
➣
Finally, in the "DP editor" screen, the I/Os intended for data exchange
must be assigned to the individual DP slaves.
To be able to use the practical example of the DP service, proceed as
follows (see also Chapter 16).
➣
Transfer the following COM 5430 TF/COM 5431 FMS database file to
the CP you are using.
– When using the CP 5430 TF under the network file
DPO@@NCM.NET the file ODPTLN1.115.
– When using the CP 5431 FMS under the network file
DPQ@@NCM.NET, the file QDPTLN1.115.
➣
Transfer the STEP 5 file DP115UST.S5D to the PLC you are using
(S5-115U). The example files are on the COM application file diskette.
B8976060/02 Distributed I/Os (DP)
11 - 39 Volume 1