Technical data

Output: Physical assignment of the output bytes of this station.
Rem. add: Remote L2 address or address of the remote station.
DSAP: Remote SAP of the configured link.
Value value of the output in KH (hexadecimal) and KM (bits).
Function keys:
F1
UPD ON
Using this key, you can update the content of the
screen. Pressing this key activates the automatic, cyclic
updating of the screen data, pressing it again
deactivates the automatic updating.
F2
STOP
With this key, you can send a stop message to the ZP.
The output values are then no longer updated. The
status field then changes to STOP.
F3
START
With this key, you can send a start message to the ZP.
The output values are then no longer updated. The
status field then changes to RUN.
F4
STEP
With this key, you can update the ZP output bytes
once. The status field then changes to STOP.
F7
SELECT
Using this key, or the enter key, you can select lines
from the complete list of the outputs screen by marking
them with the inverse bar controlled by the cursor keys.
These selected lines are then the only lines displayed
after pressing the update key F1. You exit this mode
with the ESC key.
B8976060/02 Documentation, Test
14 - 25 Volume 1