Technical data

Vendor ID: The configured vendor ID or (if possible) the vendor ID
sent by the slave is displayed here.
Group ID: The group ID of the DP slave specified in parameter
assignment is displayed here.
PLC status: The mode of the PLC is displayed here (RUN/STOP).
DP station status: Local DP master mode with the following meaning:
RUN: DP polling list is processed.
STOP: DP polling list is not processed.
Clear: DP polling list is processed, all output data bytes
are sent with the value "0".
DP station L2
address:
Bus address of the DP master station (CP), on which
you have just selected the single status function.
DP station in
ring:
yes/no: indicates whether or not the DP master station
(CP), on which you have just selected the single status
function is in the logical ring.
DP station
slave:
active/passive, indicates whether the DP slave was
configured with (-> active) or without I/Os (-> passive)
in the DP editor.
Station
diagn.:
For the meaning of the bits, refer to Section 11.7
"Single DP Slave Diagnostics").
Master Config
Check Fault:
An asterisk here indicates that the DP master of the DP
slave detected a configuration error during the
initialization phase. Possible causes are:
- configured I/O area for the slave does not match the
DP Status Poll active
slaves
Q data:
PLC -> Slaves
I data:
Slaves-> PLC
STOP
CLEAR
RUN
no
yes
yes
no
yes, Q data= zero
yes
no
yes
yes
B8976060/02 Documentation, Test
14 - 33 Volume 1