Technical data

15.1.1 Bus Selection - Creating Paths in Path Files
To be able to obtain remote active stations on the SINEC L2 bus with the
PG, the "BUS SELECTION" utility is available under the SINEC NCM menu
item. This provides tools with which you can edit paths and store them in a
path file. Selecting a remote station via the L2 bus is only possible with
S5-DOS from Stage VI onwards.
In the BUS SELECTION utility, you edit a dedicated link from a PG to the
required station.
You can then activate this path to the required station under the menu item
Init in the Path selection screen.
You can edit the paths with the corresponding station addresses both in the
OFFLINE and ONLINE mode of the programmer. In the OFFLINE mode,
the PATH is stored in the PATH FILE on diskette or hard disk, i.e. you edit
the PATH on the screen and store it on diskette or hard disk. You can only
activate a PATH in the ONLINE mode by calling up a PATH from diskette
or hard disk or by activating the PATH you have just edited.
BUS SELECTION is described in the manual for your PG
= Init Edit ...
SINEC NCM
Init-> Path Definition
Path Definition
Utilities ->Bus Selection
Bus Selection
Utilities
Menu item
Init
Menu item
Fig. 15.5 Menu Structure of the PG Functions on the Bus
B8976060/02 Utilities
15 - 5 Volume 1