Use and Care Manual

9
3. Install the ¼-inch tubing on the Feed Water Adapter using the ¼-
inch wrench. Tighten by hand, then use the wrench to tighten
another half- to one turn. If you received the Feed Water Adapter
with quick-fitting, simply insert the tubing ½ inch deep into the
fitting. It will lock automatically.
Installing the drinking faucet
1. If your kitchen sink does not have a spare ½” hole, you will need to
drill one. (Refer to Quick Tips for Drilling a Hole in Sink or
Countertop). Wipe clean and dry the area.
2. If there is a blue protection film on the Front Plate, remove it. Slip
the Front Plate with black rubber washer onto the faucet stem.
Insert the faucet stem into the hole on the counter. Optionally,
plumber’s glue or sealer could be used.
3. Under the sink, slip on the Back Washer, and tighten the Wing Nut.