Installation manual

10
Installation Manual Section 5
PUREFLOW® DIESEL SYSTEM AirDog™
FUEL LINES
THIS SECTION IS APPLICABLE TO STOCK AND SLIGHTLY MODIFIED ENGINES.
Fuel Suction Line
5 - 1 From end of fuel line supplied with attached 'Quick Disconnect' fitting, measure and
cut length of line required to connect fuel tank SUCTION port to AirDog™ inlet port
marked "Fuel In".
5 - 2 Install #8 female swivel x 1/2" 'push lock' fitting into other end of fuel line
(Ref. 5-1).
Fig. 3 Fuel line installation
5 - 3 Remove the original fuel suction line from fuel tank by squeezing the tabs on the end
of the connector together. Consult factory manual if unsure. Connect the 'New Fuel
Line' Quick Connect fitting to fuel tank by pushing the connector onto the tank
supply tube until connector seats. Check connection for seating.
Fig. 4
# 8 Flare Fitting
Fuel Line
To AirDog™
fuel “in” port
To
fuel tank