Installation manual

16
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge Cummins 1994 - 1998
Section 5-D Fuel Lines
Fuel Suction Line for AirDog
®
FP-100, cont’d
5D-2 Very Important: After removing the factory line check to make sure that
the blue plastic retainer was removed with the line. If the blue retainer remained
attached to the tank tube, it MUST be removed before the new fuel line Quick
Connect will connect and seat to the tank suction tube.
5D-3. Attach the other end of the “Suction Hose Assembly” to the male quick connect on the
top of the fuel module where the factory suction line was once located. A “click will be
heard when the assembly is properly connected.
Figure 40
5D-4. Any excess fuel hose can be addressed by routing the hose in a fashion to take up
the extra length, or a section of the hose can be removed. Push lock splices have
been included if you choose to remove the excess hose.