Installation manual

20
PureFlow AirDog
AirDog
®
FP-100 & FP-150 Dodge 2005 - Present
Section 6 Electrical Harness
Securing the Relay and Fuse Holder to the Vehicle
6-1. Secure the relay and fuse holder to the vehicle.
Figure 43 Figure 44
Connecting the AirDog
®
Power Lead Jumpers
6-2. Remove the factory wire harness connection from the top of the fuel module as seen
in (Figure 45)
Figure 45
6-3. Plug the AirDog female power lead jumper into the top of the fuel module.
6-4 After a “click” is heard, slide the red locking clip over to lock the connection in place.
6-5. Plug the factory wire harness connector into the AirDog male power lead jumper.
Again, listen for the “click”.
NOTE: The power supply leads can be connected to the battery or the alternator. Connecting
the power supply leads to the alternator instead of the battery will create a corrosion free
connection.
Black (-) Red (+)
6-6. Route the Red & Black power supply
leads to the alternator. Connect the
Black (-) lead to the alternator
Chassis Ground connection. Connect
the Red (+) lead to the alternator Hot
Lead going to the battery.
Figure 49