Installation manual

10
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-A Fuel Lines
Fuel Supply Line from the AirDog
®
to the CP-3
For the 5.9L Cummins Engine
5A-5. Connect one end of the fuel line to the
fitting on the AirDog
®
port marked
“ENGINE”. Properly torque the fitting.
To “ENGINE”
Figure 21
5A-6. Route and connect the other end of
the fuel line with the 90
o
fitting to the
fuel inlet fitting just installed on the
CP-3. When tightening the swivel,
use a back up wrench on the 12mm
fitting to preventing breaking it.
Figure 22
NOTE: It is NOT NECESSARY or recommended to keep the
factory filter canister in the system. This will cause additional
flow restriction to the CP-3. It is recommended to cap the
inlet port to the OE fuel pump and outlet port of the bypassed
filter canister.
Should you choose to keep the factory filter canister in the
system, it is recommended to install a ½” fuel line from
the filter canister to the CP-3. The optional Big Line Kit
is not included with this kit. Figure 23
Section 5 B
Fuel Supply Line from the AirDog
®
to the CP-3
For the 6.7L Cummins Engine
The AirDog
®
fuel filter is made by Fleetguard and has a 2 micron Stratapore™ media.
When installing the AirDog
®
fuel system it is recommended to bypass the factory filter
canister.
5B-1. Remove the Quick Connect fitting and the
original factory fuel supply line at the fuel
inlet port of the CP-3 high pressure pump.
Figure 24