Installation manual

11
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-B Fuel Lines
Fuel Supply Line from the AirDog
®
to the CP-3
For Model Year 6.7L Engine, cont’d
5B-2. Install the 12mm x -8 flare fitting with the
O-ring supplied into the inlet port of the CP-3
vacated by the original Quick Connect fitting.
Properly torque the 12mm x -8 flare fitting.
Figure 25
Caution: Do not over torque the 12mm fitting, IT COULD BREAK!
5B-3. Measure and cut the length of line required to connect the 'Fuel to Engine' port on the
AirDog
®
to the 12mm x -8 flare fuel inlet fitting on CP-3.
CP-3 Fuel Supply Line AirDog
®
Fuel Line to Engine
Figure 26
Figure 27
5B-4. Install a straight -8 Swivel x 1/2" Push Lock on each end of the fuel line connecting
the engine to the AirDog
®
.
Figure 28 Figure 29 Figure 30
5B-5. Connect one end of the fuel line to the
fitting on the AirDog
®
port marked
“ENGINE”. Properly torque the fitting.
To “ENGINE”
Figure 31