Installation manual

12
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2007.5 - 2009
Section 5-B Fuel Lines
Fuel Supply Line from the AirDog
®
to the CP-3
For the 6.7L Cummins Engine
5B-6. Route and connect the other end of the
fuel line to the fuel inlet fitting just
installed on the CP-3. When tightening the
swivel, use a back up wrench on the 12mm
fitting to preventing breaking it.
Figure 32
NOTE: It is NOT NECESSARY or recommended to keep the
factory filter canister in the system. This will cause additional
flow restriction to the CP-3. It is recommended to cap the
outlet port of the bypassed filter canister.
Should you choose to keep the factory filter canister in the
system, it is recommended to install a ½” fuel line from
the filter canister to the CP-3. The optional Big Line Kit
is not included with this kit.
Figure 33