Installation manual

15
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-D Fuel Lines
INSTALLING THE INTANK FUEL PUMP BYPASS SUCTION
TUBE!
NOTE: The AirDog
®
installation kit includes a Suction Tube to by pass the
“in-tank fuel pump on the 2005 - 2009 Dodge.
To install the suction tube it is necessary to either drop the fuel tank or to lift the truck bed.
NOTE: Should you choose to drop the fuel tank, support the tank as it is when it is installed
on the truck. If you let it rest flat on the floor, the tank may squash out and the suction tube
will be too short after the tank is re-installed in the truck. The suction tube, being cut too
short may suck air as the fuel drops below ¼ tank level.
NOTE: Should you choose to pull the pickup bed to access the tank. Be sure to disconnect
the tail light wires, fuel tank filler tube, and any other accessories or components that may be
secured to the frame and bed.
When Dropping the Tank, Always Remember Safety First!
Proper tools always make the job easier. The following pictures show using a transmission
jack to easily lower the fuel tank.
Figure 43
Figure 44
Figure 45
If you do not have access to a lift and transmission jack you may support
the truck on jack stands to drop the tank.