Installation manual

17
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-D Fuel Lines
INSTALLING THE SUCTION TUBE TO BYPASS THE
INTANK FUEL PUMP, C
ont’d
5D-3. Remove all burrs from the edge of the hole.
Figure 52 Figure 53
5D-4. Install the grommet in the new suction tube access hole.
5D-5. Assemble the suction tube and -8 flare x 3/8 NPT 90
0
fitting to the bulkhead fitting as
shown in Figure 52. Use diesel compatible thread sealer when assembling the NPT
fittings to the bulkhead fitting.
Figure 54
Figure 55
5D-6. Measure and cut the suction tube to a length that will allow approximately ¼”
clearance off the bottom of the tank. It is suggested to serrate the bottom of the
suction tube with notches approximately 1/8” deep to prevent possible blockage.
5D-7. Lubricate the bulkhead fitting with motor oil. Pressing firmly, insert the suction tube
assembly into the grommet. Be sure the bulkhead fitting is completely seated in the
grommet.
Figure 56 Figure 57