Installation manual

18
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-D Fuel Lines
The In-Tank Fuel Pump
VERY IMPORTANT: Before re-installing the collection basket, it is necessary to
disable the in tank fuel pump.
5D-8. You may either disconnect the power lead to the pump while
the collection basket is out of the tank and accessible……
Figure 58
OR
Locate and cut the power supply lead in the wire harness outside the tank
5D-9. Should you decide to disable the In Tank fuel pump by cutting the power lead
(Orange w/Red Stripe), you could just cut and insulate the wire (Fig 59) OR install
connectors to easily reconnect the pump later, if needed (Fig 60).
Figure 59 Figure 60
5D-10. Re-install the Collection Basket.
Figure 61
5D-11. Connect the AirDog
®
suction/supply line
to the suction tube while the top of the
fuel tank is easily accessible
Figure 62
If the fuel tank was dropped to install the suction tube, re-install the fuel
tank. If the truck bed was removed, reinstall the bed.