Installation manual

19
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-E Fuel Lines
Connecting the Fuel Supply Line from the AirDog
®
to the
Tank!
5D-1. Measure and cut the length of fuel line required to connect the fuel tank “SUCTION
TUBE” to the AirDog
®
fuel inlet port marked "Fuel In".
Figure 63
5E-2. Install a straight -8 JIC swivel x ½” Push Lock fitting on each end of the fuel suction
line to the fuel tank suction tube.
Lubricate the barb end of Push the fuel line completely
the Push Lock fitting with oil. onto the barb end of the fitting.
Figure 64 Figure 65 Figure 66
5E-3. Connect the straight -8 swivel to the AirDog
®
“Fuel In” fitting. Torque the fitting.
Figure 67
Figure 68
5E-4. Route the other end of the fuel suction line to the fuel tank suction tube.
NOTE: The AirDog® mounted on the frame with
all fuel lines attached!
Figure 69