Installation manual

9
PureFlow
®
Technologies, Inc
AirDog
®
FP-100 & FP-150 Dodge 2005 - 2009
Section 5-A Fuel Lines
Fuel Supply Line from the AirDog
®
to the CP-3
For the 5.9L Cummins Engine
The AirDog
®
fuel filter is made by Fleetguard and has a 2 micron Stratapore™ media.
When installing the AirDog
®
fuel system it is recommended to bypass the factory filter
canister.
5A-1. Remove the “banjo bolt” and the original factory fuel supply line at the fuel inlet port
of the CP-3 high pressure pump.
Figure 14 Figure 15
5A-2. Install the 12mm x -8 flare fitting with the O-ring supplied into the inlet port of the
CP-3 vacated by the original banjo fitting. Properly torque the 12mm x -8 flare fitting.
Caution: Do not over torque the 12mm fitting, IT COULD BREAK!
5A-3. Measure and cut the length of line required to connect the 'Fuel to Engine' port on the
AirDog
®
to the 12mm x -8 flare fuel inlet fitting on CP-3.
CP-3 Fuel Supply Line AirDog
®
Fuel Line to Engine
Figure 16
Figure 17
5A-4. Install a 90
o
-8 Swivel x 1/2" Push Lock on the end of the fuel line to the engine and
a straight -8 Swivel x 1/2" Push Lock on the end to the AirDog
®
.
Figure 18 Figure 19 Figure 20