Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 83
Audio source. The last character “!” is found at the end of a command code which tells
the system to execute the command.
For example, the command code
*255IAI01A,I02M,I03S! 
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255 (IA)
Input Audio selection on (I01) Input 01 to (A) auto mode, (I02) Input 02 to (M)
Embedded Audio, (I03) Input 03 to (S) 3.5mm stereo Audio (!) take the command. For a
complete list of command characters and their functions, see examples below.
Input Audio Source Select
A: Auto, M: Embedded Audio, S: 3.5mm Stereo Audio
(M) Embedded Audio refers to embedded Audio from the HDMI source or inserted
Audio from Extender Transmitter for CATx and Fiber Input Boards
(S) 3.5mm stereo Audio refers to inserted Audio from Input Board's 3.5mm stereo jack
Example:
Command Codes Action
*255IAALLS!  Set all Input Audio to 3.5mm stereo Audio
*255IAI01A,I02M,I03S!  Set Input 1(auto), Input 2(embedded), and Input 3 (3.5mm
stereo Audio)
*255IAI01-09M!  Set Input1 ~ 9 to embedded
IM: Input Video Preview Monitoring Select
The "IM" is an initiation command for Input monitoring selection. The characters and
numbers that follow the "IM" command tell the system, which Input Video to be Output
to preview monitoring port. The last character “!” is found at the end of a command code
which tells the system to execute the command.
For example, the command code
*255IMI02! 
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255
(IM) Input monitoring selection on (I02) Input 02 (!) take the command. For a complete
list of command characters and their functions, see examples below.