Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 86
57 30 0A 0D " can be sent. After receiving feedbacks from AV devices, close the port
*255IPC!
For a complete list of command characters and their functions, see examples below.
Example:
Command Codes Action
*255IPI01@001!  Open communication port with a device that is
connected to Input #1 Extender at 9400 bps baud rate
I01“abcdefg ”  Send command (abcdefg) to Input #1
*255IPC! Close communication port
*255IPI02-06@004!  Open communication port with devices that are
connected to Input #2 ~ 6 Extender at 19200 bps baud
rate
*255IPI05@004,I07@008!

Open communication port with devices that are
connected to Input #5 at 19200 bps baud rate and Input
#7 at 115200 bps baud rate
IALL"pm "  Send command (pm) to all open ports
I02"purelink "  Send command (purelink) to Input #2
I01-04"pm-256x "  Send command (pm-256x) to Input #1 ~ 4
Output Board Function Configuration
Output Board's Video and/or Audio function can be configured via command control.
Configuration command can be sent to individual port or multiple ports at once.
OM: Output Audio select on HDMI/SDI command
OS: Output Audio select on CATx/Fiber port command
OT : Output Audio test pattern select command
OF : Output channel information request command
OE: Output Extender Scaler timing select command
OP: Output Extender command transmission (pass through) command
OH: 3G/HD-SDI Output Scaler timing select command
OM: Output Audio Select on HDMI/SDI port
The "OM" is an initiation command for Output Audio selection on HDMI/SDI port. The
characters and numbers that follow the "OM" command tell the system, which Output
#'s HDMI/SDI Audio will be set to which Audio source. The last character “!” is found at
the end of a command code which tells the system to execute the command.